Don Ehrlich wrote:
>
> I just noticed that my K3 (ver 2.76) changes receive frequency when the
> RIT/XIT encoder is turned regardless of whether or not RIT is turned on.
> No LEDs are lit when this occurs. When RIT is pressed to turn on RIT all
> is as I expect but when turned RIT off I still get frequency change when
> turning the RIT encoder.
>
> Is this normal?
Yes, check your config VFO OFS setting. From the user's manual:
"If ON, the RIT/XIT offset control can be used to tune VFO A in large steps
when
both RIT and XIT are turned off. The step sizes vary with mode (see VFO
CRS),
and are the same as the COARSE VFO tuning rates."
73,
Barry N1EU
--
View this message in context:
http://n2.nabble.com/Regarding-the-Power-On-Banner-tp2139469p2139705.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
