I just completed the Test and Alignment Part I. All tests passed with flying colors. However, when I set the AGC Threshold Voltage using R1, the maximum voltage I was able to reach was 3.67V with the pot at the end of its range. I checked this value with both my DMM and the onboard volt meter and they agreed within 0.07 volts. Is this an issue since I was unable to achieve 3.8 Volts? If so, where should I look for the problem?
Thanks in advance, Fred, KC9QQ
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
