Re check the configuration of the filter used in transmit. I had a similar problem when I first put my K3 together. Fern
----- Original Message ----- From: N1IX To: [email protected] Sent: Monday, January 26, 2009 8:15 PM Subject: [Elecraft] Power output problem with K3 I suddenly developed a RF power output problem with my K3:( The power output just drops to zero. A quick power cycle fixes the problem temporarily. (not enough time for the K3 to cool off) These are the things I have done so far. There is no error message. If I don't use for the transmitter for quite a while it continues to work much longer. 1. It happens on any band and with different antennas. 2. It happens at 5W as well as 100W 3. It happens when transmitting into a dummy load. 4. It happens in SSB as well as CW. 5. Antenna port 1 or 2 Has anyone else seen this problem? Can you think of anything else I should try? Dave N1IX -------------------------------------------------------------------------------- _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com -------------------------------------------------------------------------------- No virus found in this incoming message. Checked by AVG. Version: 7.5.552 / Virus Database: 270.10.13/1916 - Release Date: 1/26/2009 7:08 AM
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
