Sam, I am not using a Softrock with the K2, but the principle is the same as that indicated in the article you referenced. The K2 IF center is close to 4913 kHz, but will vary from K2 to K2, and the CW center frequency will be different than the SSB filter center.
Your softrock receiver will have its own center frequency. So do exactly as the article says - subtract them and enter that into PowerSDR as your initial trial. That will get something on the screen at approximately the frequency indicated by PowerSDR. That can be refined by using a signal of known frequency. 73, Don W3FPR Sam Morgan wrote: > Here is my question: > If anyone is using this PowerSDR-IF software > with a Softrock as an IF for a K2.............. > > What IF Frequency(s) have you entered on that "Softrock IF Stage" tab. > for LSB, USB and CW ? > > About 3 pages down from: > http://www.wu2x.com/sdr.html#gettingstarted > > you will find an image of the "Softrock IF Stage" tab: > http://www.wu2x.com/images/setup2.jpg > > http://www.wu2x.com/sdr.html > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
