I believe what Mike is asking for is to have BSET mode be more comprehensive -- to include things like direct frequency entry and all of the other controls that are normally accessible only for the main receiver.
The BSET switch *is* intended as a context swap that allows the front panel to control the sub receiver. It already allows control of many sub receiver parameters, including the DSP controls, mode, preamp, attenuator, and antenna selection. As part of the sub receiver band-independence feature (which I'm working on right now), I'll be adding additional controls to BSET. I've already added BAND change and noise blanker control. I hope to have a beta version of this code available within a week or two. It mostly works, but I have some refinement to do before I let it out of the lab. 73, Wayne N6KR >> I have been using the K3 sub rx for a while now. >> What I would like to see is a totally interchangeable main and sub. >> I want to be able to switch sub for main in a way that the sub rx is >> acting like the main without a shadow of a difference. Right now if >> I press Sub I can change sub rx settings but I can't change >> frequency for example. >> I would like to be able to operate as if the Sub were main and the >> Main were Sub and vice versus perhaps by pressing a single button. --- http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
