Roy Morris-6 wrote:
>
> I would like to back up my CONFIG settings
>
One more point. The Utility Configuration Save is saving much more than
just your CONFIG settings. It saves EVERYTHING including all calibration
constants. So anytime you do a recalibration, change your XFIL parameters,
etc you should do a new Configuration Save.
If you have trouble putting your K3 into a particular mode, you can also use
SAVE/RESTORE to do that. For example if you had a complex setup using a
Transverter, you could save that under a separate "Transverter" file and
recall it whenever you wanted to go into that mode.
73, Bill
--
View this message in context:
http://n2.nabble.com/Recalling-CONFIG-Settings-tp2258408p2258559.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
