I just completed my K60XV, have installed it in my K2 and am going through the 
Alignment and test procedures.

My voltages check out OK in the 40/60 Metre Alignment section.

"Connect an antenna to the K2.  While listening to and noise or a weak signal" 
(your typo, not mine) .... peak the signal by adjusting C1 and C2.  I notice no 
difference when adjusting either of them.  Is it a subtle peak or sharp and 
pronounced?

I connect a dummy load and set the power to 2 watts.

"Enter TUNE and adjust the two trimmers for maximum power output."  -- Well, I 
can adjust them and get anywhere up to 15 watts out.  But I don't think that's 
what you mean, is it?  If you want me to set the power output to 2 watts then I 
assume I should tune to get about that, shouldn't I?  What do you really want 
me to do here?

Thanks in advance for any assistance.

73 - Ken Alexander, VE3HLS


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to