Although not mentioned in the release notes, this problem appears to have been fixed in the 2.80 beta release. Thanks Wayne, Lyle, or whoever was responsible. :-)
73 -- Joe KB8AP On Dec 25, 2008, at 7:37 PM, Joe Planisky wrote: > Hi all, > > I've just discovered something odd with my K3 (#1772). When I > switch mode from DATA to AM via the front panel Mode button, the rig > tries to transmit. The red TX light comes on momentarily and I get > a ERR TXF message (if in band) or an END message (if out of band) in > the VFO B area. I don't have the AM filter installed, so I don't > think anything is actually going out over the air, but it doesn't > seem like the rig should ever go into transmit on a mere mode change. > > It ONLY happens when going from DATA to AM, not when going from FM > to AM or between any other modes in either direction. There is no > mic connected to the rig, nor anything connected to the rear panel > mic or line inputs. The only things connected to the rig are a > paddle, an external speaker, and the antenna. It happens whether > in VOX or PTT mode. > > I first noticed it with MCU 2.67 (although I can't say if it > happened with earlier versions.) I've updated to the 2.76 beta > release and it still happens. > > Anyone else see this? > > 73 > -- > Joe KB8AP ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
