Hi Steve, Seems to work correctly here even if I exceed the recommended 5 bars of ALC.
73 Doug N3QW ----- Original Message ----- From: <[email protected]> To: <[email protected]> Sent: Wednesday, February 11, 2009 9:16 AM Subject: Re: [Elecraft] K3 Beta firmware rev. 2.82 > > I installed the new beta last and tested the new output power control. I > don't see any improvement in PSK31 output power using DATA A mode. I still > get nearly twice the output power than I have dialed in by the PWR knob. > In > the previous firmware, the measure output power in CW modes agreed with > the > PWR knob setting, but now the power output in CW is 20-30% higher than the > setting. > > I will try to redo the transmitter gain calibration to see if this helps. > > Steve N9SZ > K3 #1672 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
