Damon, Here is where things get hard and complicated -- 2 wide header pins ar numbered differently than ICs. Start at pin 1, then pin 2 is on the other side of the two rows, pin 3 is next to pin 1, etc. Net result is that the odd numbered pins are on one side and the even numbered are on the other. I hesitate to mention that the DBxx series of connectors is numbered differently than either ICs or header pins - sory, but it is a confusing world. The one thing that helps is that the Elecraft schematics show the proper numbering of the pins. Other schematics are not so kind and simply mark the pin number, but show the connector or IC as a block with the pins numbered in some random order.
The pin that is cut off on the header is pin 4 which is unused (pin 1 is at the top of the control board toward the edge). Your K2 must have had the KPA100 installed at one time, and for that installation, pin 4 is cut off and the connecting ribbon cable is keyed. Since the KIO2 AUX board cannot be successfully installed upside down and allow the top cover to still be installed, keying of the mating connector is not necessary. BTW - if you have the KAT2 as well as the KIO2 installed in that K2, the green wire on the KAT2 connector must be at the top. 73, Don W3FPR W4HDM wrote: > Don, > > Thanks for your help, yes that was the problem ...my lack of > experience! After counting the pins the correct way the voltage is now > within specs with a -9.6. > > My electronics building started just 2 days ago. I went to the local > electronics store (Fry's) and purchased a Hakko 936 soldering station and a > cheap sounds to lights kit to see if I was capable enough to continue. It > worked after assembly so I moved on to my K2 and built the 160m mod ... hey > it worked as well and looked pretty good! SO .. this KIO2 is my 3rd attempt > at building. Now that I have the pin counting down I'll proceed with crossed > fingers! > > BTW ... at P4 on the control board where the AUX board will plug in, pin 9 > (using your method) has been cut out and there is no wire going to it from > the tuner. Is this a normal mod and should I cut any of the pins from the > new AUX board? I assume it was cut to prevent some sort of short if it was > plugged into wrong? > > Thanks again! > > Damon > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
