I wonder if anyone else has experienced the following? (and what the cure was?)
In a k3 with atu xverter interface and subrx. Ant 1 is selected vfo a is set to cw mode and receives OK. Keying it shows rf output on the k3 power meter and the external power meter vfo b is set to cw mode on the same band. Doing an a/b swap and it receives OK, Keying it shows rf output on the k3 power meter and the external power meter if I activate split (rx a tx b) using the above settings, keying shows rf output on the k3 power meter and the external power meter however if I activate the subreceiver with split (still) enabled keying shows NO rf output on the k3 power meter and NO rf on the external power meter. A signal can be heard on a monitor receiver. Also if I leave the subreceiver activated and turn off the split (no split) keying still shows NO rf output on the k3 power meter and NO rf on the external power meter. A signal can be heard on a monitor receiver using <bset> <ant> changes the subrx receive path as expected but doesnt affect the tx output I was using the 2.82 software. I rolled back to 2.76 but still have the same issue Dave ww2r ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
