Greetings,
I do not have a roofing filter in slot #5, slots 1 through 4 are filled. I
manually set up filters via the K3, leaving the BW on slot #5 as 0 (zero) and
the K3 didn't balk. Later I downloaded the latest firmware w/o any problems
(apparently), and while in the K3 Utility I attempted to reset the crystal
filters. Leaving the slot #5 BW as zero, I get an error msg stating: "Empty
filter slot 5 (zero bandwidth) filter cannot be enabled for any mode" when
Accept/OK is selected. I have a 0.40 KHz in slot #4, so I just put that BW
also in for slot #5 and it accepted the config.
I don't find anything so far that indicates how to handle no filter in slot #5
while using the K3 Utility. Is it OK to lie to my K3? :-( Words of wisdom
appreciated. Thanks. 73
Walter, N0DZJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
