I want to close out this thread now that my KX1 is back on the air on 80, 40,
30, and 20 meters.
I was doing another close visual before following up on Don's advice to
remove Q9. During that process I must of dislodged something that was
causing a short in the vicinity of T2. There were a couple of through holes
I had difficulty clearing to mount T2 and I think perhaps there was solder
ball or something that was hidden by T2. Once dislodged everything came
"back to life". Needless to say I was quite relieved!!
So, this re-enforces Don's advice to check the soldering closely and perhaps
to pay attention to any solder debris that might be left "laying around."
Don - thanks for the tips and assistance to help me through this.
73, W4SDM
Shawn Morrow
Fairfax, VA
-----
Shawn Morrow
W4SDM
--
View this message in context:
http://n2.nabble.com/KX1-appears-dead-after-KXB3080-PCB-installed...-...Help-please%21-tp2266733p2344222.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
