LB3SA wrote:
>
> I have a K3 with all modules except transverter interface. The radio does
> not communicate with the PC (or Mac) before it has been on for about 45
> minutes - consistently. I turn on one of my rig control/logging programs
> or K3 utility right after the radio is turned on. Without touching
> anything the communication does not start to work before the radio has
> been on for between 30 and 45 minutes.
>
> If this had been my K2 I would have checked for dry/cold solder joints but
> since this is a factory built module I chose so far to leave it alone.
>
I'd contact Elecraft support and see if they would exchange the KIO3 module.
I suppose you have tried with a different serial port? It might be that
which has the warm-up problem.
-----
Julian, G4ILO. K2 #392 K3 #222.
http://www.g4ilo.com/ G4ILO's Shack http://www.g4ilo.com/blog.html G4ILO's
Blog http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3
--
View this message in context:
http://n2.nabble.com/K3-rig-control-with-RS-232-does-not-work-with-%27cold%27-radio-tp2392599p2392793.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
