> After connection at 4800 baud, > DS; returns the frequency > SW20; enters tune mode (I changed the tune mode to CALS to > have enoogh time for the following command) > DS; returns a "?", although I see the SWR on > K2's LCD
Hmmm. DS; may not work during transmit on the K2. My K2 is not hooked up, so I cannot test. Could someone please confirm whether DS; works during transmit on the K2. If not, this method will not work. :( David, W4SMT --- On Sat, 3/14/09, ub5_073_oleg <[email protected]> wrote: > From: ub5_073_oleg <[email protected]> > Subject: Re: [Elecraft] KIO2, KPA100 - is SWR value available via RS232? > To: [email protected] > Date: Saturday, March 14, 2009, 4:14 PM > David, thanks for your reply! > > I gave it a try in a terminal program. > > After connection at 4800 baud, > DS; returns the frequency > SW20; enters tune mode (I changed the tune mode to CALS to > have enoogh time for the following command) > DS; returns a "?", although I see the SWR on > K2's LCD > > Am I doing something wrong? My firmware is 2.04P 1.09 > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: > http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
