Hi Don, Your correct! I think I needed to take a break. As far as my DMM is concerned it reads 0.F M ohm when the probes are not in contact with anything so once thanks for the information.
Ed, 73, KE7HGA On Mar 16, 2009, at 4:35 PM, Don Wilhelm-4 (via Nabble) wrote: > Ed, > > KX1 U6 pin 3 is connected to ground, so you should have a very low > resistance reading. The resistance chart on page 42 3rd item from the > bottom indicates that the reading should be less than 5 ohms. > It sounds like yours passes with flying colors. > > I cannot comment correctly on the high resistance reading from your > particular DMM, but you may want to consult the instruction sheet for > that DMM. > Infinite resistance should appear the same as the reading wihich you > obtain with both probes out in thin air, touching nothing. > > 73, > Don W3FPR > > EMD wrote: > > > Well I finished phase II and I have a problem with the resistance > checks with > > U6. Pin 3 should be > 10k but I am reading .1 to .2 ohms. The > next thing on > > Pins 1 and 2 are showing 0.F M ohm which I think indicates infinite > > resistance so I think thats okay? I checked for a cold solder > joint and it > > looks good so I think U6 is dead. If so how do you replace U6? > > > > 73, > > Ed KE7HGA > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:elecr...@... > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > > This email is a reply to your post @ > http://n2.nabble.com/KX1-Resistance-checks-tp2488242p2488318.html > You can reply by email or by visting the link above. > -- View this message in context: http://n2.nabble.com/KX1-Resistance-checks-tp2488242p2488376.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
