The K3 Utility's save/restore is "all or nothing", and it takes a while to perform. It's not a "click on a box" experience; it takes minutes and a full MCU reset.
Different objectives. Bill has done a fine job with K3-EZ. http://home.roadrunner.com/~n2bc/SW.htm Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Joe Planisky Sent: Wednesday, March 18, 2009 10:57 AM To: David Gilbert Cc: [email protected] Subject: Re: [Elecraft] AGC settings with Firmware 3.03 Couldn't you do this already with the K3Utility's save and restore configuration feature? 73 -- Joe KB8AP On Mar 18, 2009, at 10:04 AM, David Gilbert wrote: > Personally, I > think a neat feature for a piece of software like K3_EZ would be to > allow multiple combinations of AGC settings that could be stored and > recalled as needed for changing conditions instead of having to change > each parameter singly and separately. Just click on a box (say one of > five or six?) and send the appropriate full set of AGC settings to the > K3 on the fly. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
