Hello Elecrafters,
In the archives there are several messages regarding the effectiveness or
lack of effectiveness of the KNB2 noise blanker for the K2. Having just
finished assembly of one for my recently completed K2 I wanted to share my
findings.
This kit is an easy build with only three simple toroid coils to wind. There
are no transformers. The one SMD device is pre-installed on its own small
circuit board and caused no assembly problems.
Installation of the KNB2 caused a very small loss of sensitivity in the K2.
This is not noticeable with off the air signals but was detectable when
checking MDS with a calibrated signal generator. Sensitivity is still more
than adequate for the HF bands.
The noise blanker is very effective in reducing my local power line noise. Weak
signals on 20 meters that were not copyable before are now Q-5. According to
the S meter the noise is being reduced from 20 dB over S9 to a level of only
about S3 with no noticiable signal distortion.
I am very pleased with this accessories for my K2.
73,
Bill - K6WLM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
