Dave, 6 m is mapped in . I double checked that,
I will try some older versions of the FW this morning. Arie PA3A -----Oorspronkelijk bericht----- Van: [email protected] [mailto:[email protected]] Namens Dave G4AON Verzonden: zaterdag 4 april 2009 8:42 Aan: [email protected] Onderwerp: Re: [Elecraft] FW 3.06 - 6m missing Mine is OK, have you checked 6m isn't also mapped out? 73 Dave, G4AON K3/100 #80 f/w 3.06 ======================= Loaded FW 3.06 yesterday. All OK except.... This morning I cycled through the bands and found 6 meters missing. I am sure that 6m is mapped in. Checked that with K3-EZ and in the config. What happens is this: Cycle up through the different bands and after the 10m band comes 6m? No band noise, not even with pre-amp on. AND the display says 30.000.00 Touching the VFO changes the display to 29.999.99 and the band noise comes in. So probably I'm back at 10m. Another thing I tried was this: Switch to config and go to the band mapping. Cycle through the bands until you reach 6m, and yes it is mapped in. Leave config. Display is at 30.000.00 and K3 reacts the same as mentioned above. Only band I have mapped out is 60m. Am I the only one with this problem? Or maybe I've missed something. 73 Arie PA3A ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
