Ken . . . Yes, it's normal. The K3's External ALC is slow acting, but the Quadra's output WILL settle down to 1000 watts provided you have calibrated the Quadra's ALC for 1000 watts output. This will vary by band, but as long as the variance results in an output of less than 1000 watts and not more, you're ok. The receiving station will not notice the difference.
On CW the slow-acting ALC is not a problem. On SSB you will want to make sure the MIC gain is adjusted so you aren't over-driving the Quadra. Depending on your microphone, a MIC setting as low as 2 may be normal, with minimal if any compression needed. If you haven't yet looked at them, you might want to read two documents on the N0SS website . . . http://www.n0ss.net/k3-to-quadra_docs_v1r9.pdf http://www.n0ss.net/k3-to-quadra_comments_v1r2.pdf Let me know if I can help further. 73, Kent K9ZTV Ken Roberson wrote: > Hello All, > I have the Band decoder working and now > working on the ALC , it seems to work , but it's slow to react , Is this > normal?? > The Amp goes to 1200 watts at first then back to 840 watts ??? > Thank everyone for all your help. > Ken K5DNL > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
