Ric Porter wrote: > After 5 months use my K3 has developed an output problem. The output varies > on tune or key down. If it is set on 100 watts, say on 20 meters, the out > put will start at 65 watts. It then goes up to 110 and settles at 100 > watts. All this is in a span of about two seconds. It does the same at five > watts, or any power. It does the same on any antenna. It is ok at 1 mil > through the two meter transverter. There is no device between the K3 and the > different antennas. The variation is greater at the higher frequencies but > does occur on all bands. > First thing I would do is check it into a dummy load Ric. Does it still do it then? If so, try reloading the firmware and make sure you rewrite the tables. See if that helps.
73 Ian -- Ian J Maude, G0VGS SysOp GB7MBC & HB9DRV-9 DX Clusters Member RSGB, GQRP, FISTS K2 #4044 |K3 #455 http://www.amateurradiotraining.org ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
