Thanks Don. I do have the RE installed. This was a fully functional K2/100 with all internal options that has been in storage for several years. I'm dusting it off and going through it thoroughly, from a factory reset. That explains the D19 = Y problem. It has a couple of other problems, notably bad AGC (can't set up S-Meter LO and HI properly), and "dead" on receive. Step at a time.
Thanks again, Don. On 5/7/09, Don Wilhelm <[email protected]> wrote: > Jim, > > Do you have the Rework Eliminators installed in that K2? If so, follow > the instructions in the RE manual about the additions for the K60XV > option. C71 is changed to 120 pF with the RE change or the installation > of the K60XV and requires that you set the secondary menu to D19 = Y. > > After you install the K60XV, you will have to revisit the VCO voltage > settings following the instructions in the K60XV manual. > > 73, > Don W3FPR > > Jim Brown wrote: >> I set the VCO voltage at 4.0Mhz to 6.0v with L30. On 40M, the voltage >> is 8.31v and does not change as the VCO frequency is varied. All other >> bands are within range and behave normally. I don't know which >> relay(s) (K13-K15) or capacitor(s) (C70-C75) may be at fault. Any help >> appreciated. >> >> Regards, >> Jim K5JAZ >> K2 #2535 >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
