Hi - I'm in the process of building my K2. I've completed the control board, and am performing the resistance checks as recommended in the manual. All check out OK except for the test for pins 29 and 30 of U6 (the dash and dot/ptt pins). The resistance values as stated in the manual are 70-90 kohms. I'm reading 96 kohms on both pins. Do I have a problem? My DMM is an inexpensive one, so is the 7% deviation to be expected (within tolerances). If this is bad, any ideas on what to check? Thanks,
Dan Kreithen AE3E [email protected] _________________________________________________________________ Hotmail® goes with you. http://windowslive.com/Tutorial/Hotmail/Mobile?ocid=TXT_TAGLM_WL_HM_Tutorial_Mobile1_052009 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
