Good job, Drew! I repeated your steps and confirm the same result: 40m is mapped out. Now that it's repeatable it can be fixed. (BTW, I'm running FW 3.11)
73 -- Joe KB8AP On May 15, 2009, at 6:54 PM, drewko wrote: > Try the following. > > Assuming all your ham bands are mapped "IN", except 5.0 MHz: > > Starting somewhere on the 40m CW band... > FREQ-ENT 5.990 ENTER > Move VFO to somewhere above 6.000 > BAND-UP > > You end up on 30m (not in the 40m ham band as you would expect). > > Go to CONFIG BND MAP and use BAND-DOWN to select 7.0: It has been > mapped "OUT". > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
