If this is a serious issue to folks as it appears to be, use a power supply with remote sense and attach the sense lines at the Powerpole at the back of the K3.
My gut feel is the DX will never know the difference. Terry ----- Original Message ----- From: hb9brj To: [email protected] Sent: Wed, 3 Jun 2009 17:59:42 +0000 (UTC) Subject: Re: [Elecraft] K3 voltage under load When switching my K3 from RX to TX 100W FM, I measured these voltage drops: 0.03V directly at the Astron RS-35M's output 0.25V at an unused output of a WMR RIGrunner, connected to the RS-35M by a 2ft cable 1.00V as indicated by the K3, connected to the RIGrunner by a 4ft cable By cable I mean the type supplied with the K3. Certainly not as good as the 400mV reported by Guy K2AV. Still better than the 1.7V reported by Harris K9RJ. Corresponds to the 700mV reported by Joe W4TV (direct connection, no RIGrunner) Guess the major problem resulting from voltage drop is a reduced efficiency of the KPA3. 73, Markus HB9BRJ -- View this message in context: http://n2.nabble.com/K3-voltage-under-load-tp3010557p3019971.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
