Hi Bill, Just hold SUB until you see "LINK" displayed (about 1/2 second). The kHz decimal point of the VFO B display will flash as a reminder that the VFOs are linked. (If you continue to hold SUB, it will turn on the sub receiver and put the rig into diversity receive mode.)
Once the VFOs are linked, you can tap A->B, then offset VFO B as desired. VFOs A and B will track at the established offset until you unlink them. 73, Wayne N6KR On Jun 10, 2009, at 4:46 PM, Bill W5WVO wrote: > I seem to recall some discussion about this a while ago, but can't > locate it now -- Is there a way to make the two VFOs track each other > by a certain offset? In other words, I set VFO A to 50125.0 and set > VFO B to 50125.7, and when I turn the VFO A knob, both VFOs tune, > maintaining the 700 Hz offset? If this is not possible with one RX is > it possible using the KRX3? > > Bill W5WVO --- http://www.elecraft.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
