One other stupid question... In prep for FD I decided to do some TX tests... I found that the radio starts limiting power output and giving HI CUR messages around 66 to 68C PA TEMP. I recall Eric stating that the rig would be fine to 85C. Is this HI CUR message normal at this range? I'm transmitting into a 50 ohm load that is capable of 100 watts continuous and transmitting at 100 watts.
Thanks ~Brett On Thu, 2009-06-18 at 21:46 -0700, wayne burdick wrote: > 100% normal -- not to worry. > > If the entire panel starts to glow, reduce CW speed. > > 73, > Wayne > N6KR > > On Jun 18, 2009, at 9:40 PM, Brett Howard wrote: > > > Is it normal for the right side to run quite a bit warmer after > > installation of the KRX3. I did a quick google search and no nabble > > hits came up. I'd assume that the two regulators on the right side are > > running warmer because of the greater consumption. I assume that when > > the SUB is off that this will run cooler but haven't tested this yet... > > > > ~Brett > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > > > > > --- > > http://www.elecraft.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
