This is probably an N1MM issue but thought someone on here may have something useful to say....
I finally got round to properly setting up the dual transceive SO2V on my K3 for N1MM and it seems to work a treat. I can now have the 2 entry windows open with VFO A running and B set for S&P on the sub receiver frequency; <CTRL Left/Rt Arrows> flick between A and B (invoking SPLIT for B to tx on the sub qrg) and while running I can hit <\> to put an S&P call in the VFO B box to check for a dupe etc. Just one minor annoyance/oddity; I use ESM all the time (mainly cw here) and have a footswitch on an LPT port set for "ESM ENTER". But it appears the footswitch only acts on VFO A which is normally set up for running. So if I've swapped to VFO B to S&P someone and then hit the footswitch to send my call (F4) the focus swaps back to A and I end up calling CQ on my run frequency instead. No problems if I use the keyboard ENTER key. I've tried changing the LPT Radio number from 1,2 to Both etc but no difference. Any ideas folks? I'm assuming it's an N1MM issue so it's also gone onto the N1MM Yahoo board. 73, Stewart Rolfe, GW0ETF -- View this message in context: http://n2.nabble.com/K3---N1MM%2C-footswitch-and-ESM-action-tp3132037p3132037.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
