Brett wrote: Ok so I just found a problem when digging around in the radio. Looks like the screw in the top of the KAT3 board wasn't replaced. Putting that screw back in makes the radio show the signal at S1.
---------------------------------- Good eyes! That's a real easy one to forget since it's nearly hidden under the lip on the rear panel. You're not the first to have strange problems caused by a poor ground at the KAT3 because that screw is missing. Because of the work I do I've had my K3 apart - literally from a fully-assembled rig to a kit of parts again and everything in between - more times that I can possibly count. I have some small containers in which I put the hardware when disassembling. If I'm disassembling parts that include critical but close screw sizes - such as the front panel bezels - I use more than one container. I always start with *empty* containers. When the radio is back together, I check to be sure the containers are empty. If not, I go hunting for where I left out a screw or a washer. Ron AC7AC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
