Sounds like you didn't get the current instructions Dale and I don't find them on the web site either!
I'll send them to you off the reflector. Ron AC7AC -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dale Harding K7DNH Sent: Friday, June 26, 2009 7:16 PM To: [email protected] Subject: [Elecraft] Heil Proset-k2 with K3 - Settings please for newbie Newbie question - I dont want to take the chance to fry something. I want to start using the Heil Proset-K2 I ordered with the K3 - but a bit unsure of exactly how to set it up. THe instructions that came with it are mostly for installing the necessary kit into the K2. I searched thr reflector for the setting to use and came up with opposing views... the majority stated if using the front panel use the following: Use the adapter supplied and plug in both connectors and then into the k3 front panel, FP Low - with bias on, Vox On, VOx gain = 50, antivox=00 To use the rear panel - do not use the adapter " and plug the connectors into the repar panel jacks - well - exactly which ones? The only two that the large one will fit is the paddle and the key. Apprecaite your help folks, Dale K7DNH -- View this message in context: http://n2.nabble.com/Heil-Proset-k2-with-K3---Settings-please-for-newbie-tp3 164969p3164969.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
