Hi Pete, That is version "C" KPA3. I commented on that and sent pictures to the support team a few weeks back.
Yes either they need to go back to the other design or just use an split washer instead of the inside tooth washer. I choose to keep the inside tooth washers and just push it work all it was worth with my finger nail. I got it stuck the first time and had to loosen the screw to free myself. :-) The old PA didn't have this problem as the trace was move closer to the edge of the board. 73 de jay/w5jay.. > Good evening, > While installing the KPA module in my freshly built K3, I noticed the > inside tooth washer on one of the mounting screws fastening the PA module > to the screen comes perilously close to a trace. It is the screw closest > to a board mounted trimmer, and the trace comes from a to-220 device. Is > there something I overlooked, or is this a non issue? I didn't see > anything on a basic search of the archives > Thanks, > Pete > -- > Pete Axson > W4SEC > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
