Hi John:
You will need a buffer amplifier between the IF output of the K3 and
even then, it will not drive the SM-220 properly. I've tried it and was not
happy with the end results. Fern
----- Original Message -----
From: "JPHN POWELL" <[email protected]>
To: <[email protected]>
Sent: Wednesday, July 01, 2009 4:55 PM
Subject: [Elecraft] INTERFACING A KENWOOD SM220 BANDSCOPE WITH A K3
>I am intending to interface my K3 with a Kenwood SM220 and installed the
>Elecraft KXV3 Interface to achieve this. Is there any other problems that may
>occur, other than to retune the SM220 bandscope input to the K3 IF frequency ?.
> Comment and suggestions, ideas, etc. will be most welcome
> Thanks in advance.
>
> John Powell. ZL1BHQ
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
