Are you sure the preamp state is the same for both receivers? Remember it is band-specific. (I was caught by this once. :=)
Al N1AL On Thu, 2009-07-02 at 20:21 -0700, Allan Taylor wrote: > I finally emerged from a very busy spring and had a chance today to go > over operation of the KRX3 in my K3. > Joe, KB8AP, came over and we played for most of the afternoon. Things > are just peachy except that we > noticed on 30m (only) that the KRX3 is consistently much less > sensitive on 30m than the main RX. Other > bands appear to be operating correctly. We tried all combinations of > input antennas, etc. Filters are identical. > All settings apparently identical. > > In fact, this discrepancy won't likely be a major issue for me, but I > would like to figure out what's up and get it > fixed! > > K3 S/N 740, factory updated with KRX3 in April. Identical filters in > both. Running 3.19 firmware now but > behavior identical to that of April (2.??). > > Any ideas?? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
