David, You can easily check to see if the amp keying is compatible with the K2 keying interface - all you will need is a DMM.
Power the amplifier and measure the open circuit voltage at the "PTT" or "KEYING" input. If that voltage is positive and not higher than the breakdown voltage of the K2 keying mod output device, then so far, so good. If all was good for that last test, proceed with the test, but if it was not good, you will need an interface of some sort (relay or other). Now set your DMM to measure current and place one probe on one side of the PTT input to the amp and the other probe to ground (or the other side of the PTT input). Expect the amp to key, so protect it with a dummy load. Your meter will tell you how much current is required to key the amp. If that current exceeds the current rating for the K2 keying mod output transistor, you will need an interface, but if it is within the current rating, then connect them directly. 73, Don W3FPR [email protected] wrote: > Hi All, > > I'm in the process of aquiring a old kenwood TL-120 100w amp, which I plan > to drive with my K2. > > Just wondering if anyone has any details of doing this, before I try and > figure things out for myself. My K2 is modded with a external keying > output, and I'm wondering whether I can use this to key the TL-120 > directly, or whether an additional interface will be required. > > Cheers > > David, VK2NU > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
