So I removed R6 in my attempt to isolate my problems with my power readings and I found the DC voltage on U4, pin 1 to be .01V so obviously there's a problem. The directions suggest checking T1. I did not build this board so I don't know if the windings of T1 were shorted when it was made but they appear to be now that it is on the board. Are the red and green wires supposed to be shorted when its on the board? (after some study of the schematic, it is clear that they are now shorted on the board) I am not sure where to look next. I've reflown all the solder joints with no change and U4 has power. I don't know where to look next! Some guidance would be great.
Tom ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
