Gene wrote: >Just purchased a K1 ... Full output on 40 and 20 meters. No output on 30 and >15 meters.
That's a bit odd. Normally 40/30m will have problems, or 20/15m due to slightly different signal paths through the filter board for those combos. With good output on 40m and 20m, that says that both paths are good. In addition, 40m is derived from 30m, and 20m from 15m, by trimmer capacitors that get connected across the 30m and 15m trimmers. Can you receive anything on 30m and/or 15m? The MOST LIKELY cause is a bad solder connection between the filter board microcontroller (pins 1, 2, 6, 7, 8, 9) and the actuating coil of one or more of the band switch latching relays. Relay K2, in particular, would cause exactly the condition that you are seeing if it is not getting a RESET pulse from the microcontroller as you switch to 15m or 30m. You can verify that this is the problem if you can still hear in a separate receiver the 20m crystal oscillating (near 22 MHz) when 15m is selected, and hear the 40m crystal oscillating (near 15 MHz) when 30m is selected. The 30m crystal should be oscillating (near 18 MHz) or the 15m crystal should be oscillating (near 29 MHz) when those bands are selected. Crystal failure could also cause your problem, but it is very unlikely to occur on two bands. There have been almost no reports of filter board crystal failure except for 20m crystals. Mike / KK5F ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
