My feelings are that something in the notch part of the DSP code is not being initialised properly. I have had the Auto notch both not work, then work.
73 Stewart G3RXQ On Sun, 16 Aug 2009 15:28:12 -0700, Gregory Fischer wrote: > I've talked to Lyle about this and he is going to look at it when he > gets back from a trip he is on. > > 73 > Greg > AB7R > > On Aug 16, 2009, at 12:22 PM, Dick Roth, KA1OZ wrote: > >> Tried listening for the Elecraft SSB net at 1800. There was a >> heterodyne or other interfering signal on 14.316. I tried to use >> Auto-Notch, but nothing changed. Then I went to manual and notched it >> out completely. >> >> Hope I'm not adding too much noise to the FW discussion! >> >> >> -- >> 73, >> Dick ka1oz >> Middleborough, MA >> >> Radio: Elecraft K3/100(Kit) SN 859 >> Antenna: Titan-DX >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
