This capability is already in place. You need to proceed the name of the memory with a * and they need to be in sequential memory locations in order to pull it off but once you recall one you can then tune through the memories with the VFO A knob. This is especially handy for the channelized US 60Meter band.
Read about Channel Hopping on page 40 of the current K3 owner's manual which can be found here: http://www.elecraft.com/manual/K3_Owner%27s_Man_Rev_D4_WEB.pdf ~Brett -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Wednesday, August 19, 2009 3:05 PM To: Elecraft Subject: [Elecraft] K3 Channel Changing I wonder if there is (or will be in the future) a way to store frequencies (on all bands) into memory and then be able to go to VM mode and use either the VFO A or B to rotate through all o the memories? I have owned a few radios that had this feature and it would be handy for my operating conditions. I have used the M1-M4 and the Band switching via the keypad, but find this cumbersome and time consuming as well as restrictive. If this has been addressed previously then apology is given but I don't have time to read all the traffic on the reflector. 73's Gary. VK4WT/P Sent via BlackBerryR from Telstra ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
