When either the KPA100 or the KAT100 (or both) are detected, the KAT2 will be switched to ANT1 by the firmware, and the L/C section of the KAT2 will be bypassed.
I am not certain why you are concerned about tuning the KAT2 when the KPA100/KAT100 are connected. When you disconnect the KPA100/KAT100 from the QRP K2, the KAT2 will still remember the last used tuning for both ANT1 and ANT2. 73, Don W3FPR dl0tuh wrote: > and without disconnecting KPA100/KAT100 ? Will I be able to tune an antenna > on KAT2's "ANT2"? (I'm afraid that the tune command will be passed to KAT100 > as soon as one is connected) > > W4HDM wrote: > >> You will not have to remove the KAT2. Once you disconnect the >> KPA100/KAT100 from the K2 The rig will operate as the normal QRP setup. >> >> > > > ------------------------------------------------------------------------ > > > No virus found in this incoming message. > Checked by AVG - www.avg.com > Version: 8.5.409 / Virus Database: 270.13.103/2378 - Release Date: 09/17/09 > 06:18:00 > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
