Olli, Sorry for the 2 day old response, but I did not see any other answers to your question. The transmit stages are associated with the main receiver - they cannot be associated with the sub-RX.
If you have VFO A on a different band than VFO B, without the sub-RX you cannot listen on the VFO B frequency, so I conclude that you have the sub-RX because transmitting without listening is poor practice that no decent ham would do IMHO. It is a simple matter to transmit on the band that VFO B is set to - simply tap A/B to swap the VFOs and you are ready to transmit on the frequency/band that was previously set in VFO B - only now it is in VFO A. This method may be different than you had with your TS-850 and N1MM, but the capability is there - just tap A/B (or have N1MM do it). 73, Don W3FPR Oliver Grossmann wrote: > Me again, > i forget, Tx on VFO B if VFO B is on different Band. > > 73 Olli, DH2WQ > > ------------------------------------------------------------------------ > > Oliver Grossmann | DH2WQ | [email protected] > > > > Oliver Grossmann wrote: > >> Hi, >> I know it was discussed before, but i haven't found a final statement in >> the archives of the List. >> My last info is it is impossible to Transmit on VFO B during Output >> Filter Switching and QSK. >> >> I'm not sure if somebody ask to switch off QSK in this split mode. >> Are there any plans to have such a feature in the future? (I really like >> this on my TS-850 in combination with N1MM) >> >> Thanks Olli, DH2WQ >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
