Chuck Guenther wrote: > Is there any problem using the Rx input jack for the RF gain cal....
No. Works equally well. > Suppose that I do an RF gain cal, then change the filter > gain (in the Crystal filter configuration part of the K3 utility) of > the > roofing filter I used during the gain cal? Should I repeat the RF > gain cal? Yes, if you want it to be as accurate as possible. But typical per- filter gain settings are in the low dB range (or should be), so a small change won't noticeably affect S-meter accuracy. > What exactly is "calibrated" during an RF gain cal? The K3 uses a low-noise JFET IF amp. Gain control of this stage -- what we refer to as "hardware AGC" -- is achieved in two ways: by varying the current through the preceding PIN-diode attenuator, and by varying the JFET source voltage (its gate is at ground, so this varies the transconductance). A very wide range of IF gain control is achieved in this manner. But the gain curve varies a bit from one radio the next, because JFET pinch-off voltage varies (the voltage differential between gate and source at which drain-source current ceases to flow). The RF gain calibration procedure injects a DC voltage at the hardware AGC control node, sweeping it slowly over a 0 to 3 V range using a D- to-A converter. The DSP measures the resulting signal level (from your XG2), building a table of control voltages vs. 1 dB attenuation steps. This table can later be used by the DSP to determine the strength of incoming signals that activate hardware AGC; it simply monitors the AGC detector voltage at the control node. S-meter readings are a composite of the detector-voltage-to-dB table value and the DSP's internal representation of signals below the hardware AGC activation level (also in dB), so the S-meter is now calibrated. The RF GAIN pot, when rotated counterclockwise, simply adds a DC voltage at the control node (via the DAC mentioned above), so it is now calibrated as well, given that the DSP knows exactly what voltage to inject to achieve the desired attenuation. Wayne N6KR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
