I’d like someone with a similar K3 configuration to help me diagnose a problem by doing a test.
Required K3 configuration: Filters- 2.7 kHz in FL1 and 500 kHz in FL2 KAT3 ATU KXV3 KPA3 100 watt amp V3.41 firmware In cw mode, set your filter width to greater than 500 Hz to engage the 2.7 kHz filter in FL1. In the Config Menu set SW TONE to ON. Set the NR to FL1-1, and cycle the NR on and off. Do you hear a continuous tone when NR is cycled on? Thanks. Steve N9SZ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
