SIG RMV does not move "real" signals. It shifts the internal signal sources such that the net is zero. All you will hear is a slight change in filter center pitch.
That said, it should, as you noted be used after checking cable orientation. 73, Wayne N6KR ---- http://www.elecraft.com On Oct 12, 2009, at 7:47 AM, Richard Ferch <[email protected]> wrote: > Bill W4ZV wrote: >> Bill W4ZV wrote: >>> >>> Have you tried CONFIG: SIG RMV? >>> >> >> This was implemented in MCU 3.03 / DSP 2.10, >> 3-17-2009...documentation here: >> >> http://www.elecraft.com/K3/k3_software.htm >> >> (K3 Firmware Release Notes, just above "New Firmware Load >> Information") >> >> 73, Bill > > Warning: CONFIG:SIG RMV can have side effects. In addition to moving > fast-moving birdies right outside the bandpass, effectively > eliminating > them, it also moves real signals by a smaller amount. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
