Reverse polarity of LED and disconnect speaker. Steve N4LQ n...@carolina.rr.com ----- Original Message ----- From: "Wayne Burdick" <n...@elecraft.com> To: "Lyle Johnson" <k...@wavecable.com> Cc: "Elecraft Reflector" <elecraft@mailman.qth.net> Sent: Wednesday, October 14, 2009 9:16 PM Subject: [Elecraft] DSP red light coming on at max load
> It's official: we're running out of DSP cycles not just during NR on/ > off but also under worst-case load. > > I get a continuous DSP red LED and distorted audio (with a buzz) under > the following conditions: > > CW > CWT on > NR on, set to F1-x > DSP NB on, any setting > FIR IF filter (WIDTH > 500 Hz) > > Turning off any of these kills the red LED. > > I also get a red LED when turning NR on/off even if the DSP is not > turned on. > > So I need a workaround until you get back. One thing I could do is > defeat the CW decoder (and CWT) if WIDTH is set > 500 Hz. Other ideas? > > tnx > W > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html