Sure Bill. When feedline is wet, I alter some band segments by retuning as needed, as I operate. Then when dry, I encounter the re- tuned segments again when I encounter a high-SWR after I QSY. So then I re-tune, of course. As far as I can observe, that seems to wipe out the "wet" setting that was recorded at some nearby frequency. Seems OK. I just have to accept that I don't know where the segments are, and so I keep an eye on the SWR when I QSY (normal habit anyway).
I'll await any more helpful info from the creators. I accept that it may be simple "just keep doing what you are doing". It isn't a problem, I'll await any further understanding of the rules that the ATU memories follow. Thanks / Windy KM5Q Bill K9YEQ wrote: Thu, 22 Oct 2009 08:09:57 -0700 > Your feedline impedance changes when wet and the memory will change > in the > tuner. I would expect that is quite normal and a good thing! > > > 73, > > Bill > K9YEQ > K2 #35; KX1 #35; K3 #1744; mini mods > ATS-3B > > -----Original Message----- > Subject: Re: [Elecraft] K3 KAT3 Antenna Tuner Tutorial > > Fellows, > I'm not asking you to go off-topic with advice on my feedline. I'm > asking only about the behavior of the ATU memory system after I've > retuned a few band segments to wet condx, then condx return to dry. > > Thanks > Windy ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
