I've noticed that too, but never though much of it since the external meter and the K3 agree at 1:1.
Above 1:1, the K3's SWR indication reads lower than the external meter at 100 watts on the lower frequency bands (80, 160) but agrees well with the external meter on the higher frequency bands. The K3 and external meters agree well at 10 watts on all bands. For example, I set up my external tuner for an SWR of 1.6:1 on the external meter and transmit 10 watts on 80 M and the K3 agrees with the external meter just fine, but if I crank up the POWER while in tune I'll see the SWR indicated on the K3 drop to 1.0:1 when the KPA100 kicks in. At 100 watts out, the K3 indicates 1.1:1 while the external meter indicates 1.6:1 at all times. Adjusting the tuner for minimum SWR brings its meter and the K3 down to an indicated 1:1. I have about 18 inches of cable between the tuner and the K3. If it was going to have a significant effect, I'd expect it to show up on the higher frequencies, not the lower frequencies. Besides, all is well at 10 watts on all bands. It's a non-issue to me since all I care about is knowing I have the antenna system well matched to the K3. Ron AC7AC -----Original Message----- What power level were you using? And what type of external bridge? The K3's SWR bridge has two sensitivity ranges. If you have power set to 12 W or lower, the higher-sensitivity range is used. If you have power set above 12 W, the lower-sensitivity range is used. This is necessary to prevent heating of the transformers in the bridge. SWR accuracy will be best when you're in the upper part of each range. So, for example, it'll be more accurate at 12 W than 1 W, and more accurate at 100 W than at 13 W. But accuracy should still be reasonable even in the lower end of the range. Your external bridge may have better sensitivity at the particular power range you were using. 73, Wayne N6KR On Nov 4, 2009, at 9:13 AM, DM4iM wrote: > I don't have the KAT3, i use an external homemade tuner and a cheap > swr-meter between it and the K3. Don't know how accurate the swr-meter > is, but i notice that the K3 shows 1.1:1 while the external meter > still > reads worse. Fiddling with the controls of the tuner settles the > needle > on the external meter, while the readout on the K3's display stays > unchanged. > I posted this to the list some weeks ago, but nobody noticed. > > -- > > 73, DM4iM > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
