I was adjusting the LIN OUT level while running CW Skimmer this morning and the volume from the K3 suddenly went very loud. When I checked, I found that the AGC had been disabled.
Upon investigation there appears to be an issue with software polling the K3 while in the menu. I can almost guarantee that the AGC will be disabled if I go into the menu while a program is connected and polling the K3. You might wait a few seconds or a few minutes before it happens, though. I haven't had this occur when not in the menu. nor with the menu selected but no CAT software running. I'm using the latest beta (3.57) and a serial connection of 38400 baud. ----- Julian, G4ILO. K2 #392 K3 #222. * G4ILO's Shack - http://www.g4ilo.com * KComm - http://www.g4ilo.com/kcomm.html * KTune - http://www.g4ilo.com/ktune.html -- View this message in context: http://n2.nabble.com/K3-AGC-turns-itself-off-while-in-config-menu-tp3992827p3992827.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
