K3 beta-test firmware revision 3.62 (with DSP rev. 2.46) is now available. See release notes below.
Please send any questions to [email protected]. For instructions on how to load beta firmware, see: http://www.elecraft.com/K3/k3_software.htm 73, Wayne N6KR * * * MCU 3.63, 11-20-2009 * PTT USE WITH DVR: If the KDVR3 menu entry ‘1’ tap option is set to AUTOPTT (the default), then PTT behaves as follows: - If you start DVR message play first (by tapping M1-M4), then assert PTT during the message, DVR play will be canceled. - If you assert PTT first, then play a DVR message, it will play normally, and will complete even if you let go of PTT. You can also cancel DVR message play by tapping REC, as usual, whether PTT is asserted or not. (Or cancel from a computer using the “RX;” command – see below.) Note: If the KDVR3 menu entry ‘1’ tap option is set to USE PTT, then PTT is required as a qualifier for DVR message play. In this case, releasing PTT in the middle of a DVR message will cancel it. Remote Control Command Changes: * DVR MSG PLAY CANCEL: You can now use the “RX” command to cleanly cancel DVR message play (as well as any other transmit or message-play function, in any mode). * CONFIG:DIGOUT1 MENU PARAMETER is now accessible with the “MP" command. Values 000 and 001 only; get/set. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
