Sounds like a bug. The obvious fix its to fix your transverter so it has an offset that is a multiple of 1kHz. If it is an XV144, hard luck for a while until it gets sorted out.
Mike Graham Kimbell (G3TCT) wrote: > > I've just upgraded from firmware 3.27 to 3.63. > > I used the VFO CRS menu entry to select RND= YES so that the RIT knob > moves > the VFO correctly eg 1kHz steps and rounded. It works fine on the standard > bands. However on switching to a transverter band, the frequency is > rounded > to 20Hz away due to the transverter offset that I have set up. This is not > the desired behaviour, and has changed since f/w 3.27. The effect is the > same when using the main tuning knob in coarse tune. > > Anyone know how to cure this? > > Graham > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > -- View this message in context: http://n2.nabble.com/K3-coarse-tuning-in-a-transverter-band-tp4079010p4079095.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
