Dave, Looks like you have pointed me in the right direction. I had not done the wattmeter calibration as the manual implies that it is optional. That plus the usual inaccuracies in the average wattmeter I decided to accept the factory settings. This morning I did the procedure and thus far have not had a high current warning. Current is 1-2 amps less than before; still a little on the high side but at least no warnings about it. Knock on wood......
For the Elecraft tech writers and anyone attempting to do the procedure there is an error in the procedure. On page 49 of the Owner's Manual the last step on the bottom left should read tap XMIT rather than hold TUNE. If TUNE is used rather than XMIT the radio will output 20 watts regardless of the power set while calibrating. Thanks for the help. 73, Jim, W0EM Dave G4AON wrote: > > Jim, if you calibrated the K3 Wattmeter with a low reading Wattmeter it > would give the symptoms you describe. The calibration is optional and > calls for an accurate Wattmeter, the K3 already comes calibrated from > the factory. You might have a fault, K3 Support will be able to assist. > > I use the supplied cable and obtain good correlation to the expected > power at 5 and 50 Watts, but slightly less at 100 Watts. There is a > table of the results at: http://www.astromag.co.uk/k3/ > > I've never had an over current warning. > > 73 Dave, G4AON > K3/100 #80 > --------------------- > Exactly 100 watts set on K3. Measured about 90 watts out on two external > watt meters. One on an MFJ antenna tuner and the other is a high end MFJ > power meter. They agree within a couple of watts near 100 watts measured. > > Have a good day and 73. > > Jim, W0EM > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > -- View this message in context: http://n2.nabble.com/K3-Power-Problem-tp4116099p4118258.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html